RFDAC-71B | Analog controller

• The element with analog output 0 (1) -10V is used to control devices, luminaires, thermal actuators, and thermal heads - which are equipped with such an input
• They can be combined with detectors, controllers, or iNELS RF Control system elements.
• Potential free analog output 10mA, contact relay 16A.
• 6 light functions - smooth increase or decrease with time setting 2s-30 min.
• When switched off, the set level is stored in the memory, and when switched back on, it returns to the most recently set value.
• The analog controller may be controlled by up to 25 channels (1 channel represents 1 button on the controller).
• The programming button on the controller is also used for manual control of the output.
• The unit power supply is in the range 110-230V AC.
• Memory status can be pre-set in the event of a power failure.
• For components, it is possible to set the repeater function via the RFAF / USB service device.
• Range up to 200m (in open space), if the signal is insufficient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO² that supports this feature.
• Communication frequency with bidirectional protocol iNELS RF Control2
• The BOX version offers installation directly into the installation box, ceiling, or luminaire cover.

Technical parameters

• Supply voltage: 110 - 230V AC / 50 - 60Hz
• RF command from the controller: 866MHz, 868MHz, 916MHz
• Range in free space: up to 200m
• Indication: red LED/green LED
• Operating temperature: -15 to + 50°C
• Operating position: any
• Protection: IP30
• Dimensions: 49 x 49 x 21mm
• Weight: 52g